Race cars for sale

Vintage Formula Vee Race Car “gomots”

  • Vintage Formula Vee Race Car “gomots”

1975 GOMOTS FV For Sale

Due to health issues I am forced to sell my recently restored, race ready GOMOTS FV. The car is close to new in every way!

*NOTE 1*: The GOMOTS chassis is a copy of a Lynx B. It has a similar slightly reclined driving position to a Lynx B.

*NOTE 2*: Drivers with an inseam of 32 or less are the best fit for this chassis. Broad shoulders are a tight fit and might be fine for a driver or might be uncomfortable.

2 weekends on the car, Heartland Park, May 2022, Hallett. September 2022.

NOTE: All parts listed below were new for the build unless noted. Parts have two events on them unless noted otherwise.

Logbook with 2023 SCCA Annual Tech.

Huge photographic and written history file included.

Trailer not included.

MUST SELL!

Harry Dudley, the builder, raced this car at the FV 30th Birthday Party at Road America in 1983! See local magazine cover in the photos. You could recreate history!

Engine/Transmission:

• Farley engine refreshed by Curtis Owen of Wide Open Throttle Race Engines in KC. New crank, flywheel/clutch, valves, guides, pistons/jugs, rods by Quixote with ARP bolts, oil pump, fuel pump, oil cooler.

• Engine has ZERO time since replacement of the crank and flywheel due to gland nut failure.

• External Oil Filter.

• Pertronix Ignition.

• VeloStak velocity stack.

• Working generator w/new voltage regulator, shroud and fan that meets all vintage racing regulations.

• Custom new header and collector ceramic coated black w/one event.

• Long box with one event. Shifts smoothly!

• New axle boots.

Chassis/Body:

• Chassis is a basic copy of the original Lynx B. New taller dash and taller roll hoop to fit drivers from 5ft 4in to 6 ft 4 in.

• Media blasted, main frame rails scalloped for wider hips, steel floor meeting current SCCA regulations.

• T6 side intrusion panels. 3003 aluminum body new except for the tail section which is original.

Suspension:

• Carrera rear shocks and springs, front shocks are Bus steering dampers.

• Freshly nickel plated Z-Bar & drop links.

• New front sway bar from Quixote.

• New Upper and lower torsion arm spacers.

• Cambered front spindles from Quixote, cracked checked.

• New tie rods and rod ends, cleaned and re-greased steering box.

• New rear radius arms with new rod ends.

• Original front beam with ride height adjuster on lower tube.

• Full leaf front spring.

Brakes/Clutch/Throttle:

• Wildwood 3 pedal assembly (throttle, two brake masters, clutch master).

• Wildwood Master Cylinders and Clutch Cylinder.

• Wildwood brake bias adjuster on dash.

• New wheel cylinders, brake hardware, shoes, drums, bearings, seals. The backing plates were media blasted and painted black.

• New -3AN brake and clutch hoses throughout the car.

• Hydraulic clutch slave cylinder.

• New throttle cable, bell crank and carb linkage.

• New adjustable shift linkage, u-joints, 3D printed knob replicating the original.

•

Safety:

• Fuel Safe 5 gallon fuel cell, 2017 build date. Has yellow foam that withstands all forms of fuel. Cap has built in dipstick.

• New aluminum fuel cell cover with door to access fuel cap.

• FIA Race Quip 6 point pull down HANS spec narrow belts, Good through 2026.

• SPA 1.25L AFFF aluminum fire bottle, cable pull on dash, nozzles in cockpit and engine bay per regulations.

• Padded, adjustable headrest.

• Tall main roll hoop and tall dash hoop to fit drivers from 5ft 4in to 6ft 4 in.

Misc:

• New wiring harness

• New VDO gauges.

• New MIL spec switches.

• LED Oil Pressure Light.

• LED Rain Light.

• New Battery (New as of 4/5/23).

• New Starter.

• New Grant 10 inch steering wheel covered in Alcantara.

• New period correct rear view mirrors.

• Hoosier Vintage TD tires with 2 weekends on them.

• 5 new wheels

• Converted to wheel studs.

• Wheel mounting adapter plate (allows for mounting and balancing Vee wheels on standard tire mounting equipment!)

• FV engine of unknown status. Requires disassembly and rebuild before use.

• Long box that shifts hard. Does not crunch gears but shifts with difficulty.

• Tall Chassis Stands (waist height)

• Body Panel Stand (holds cowl and tail or cowl and nose)

• Misc new/rebuilt spare parts. (New wheel cylinders, locking tabs, misc. gaskets/seals, rear wheel bearing seal kit, etc) Used but good Carb, intake, etc.


Price: Auction

More info: Listing has ended. Click to search on eBay for similar Formula (Affiliate link)

Seller's other items: bryancohnracing (Affiliate link)

Location: Topeka, Kansas, United States

Hey! There's a sticker you might like and download right now?

Click the image to download the sticker with a transparent background.

Vintage Formula Vee Race Car “gomots” sticker preview

Download sticker PNG (transparent background)

Sticker paper for your inkjet printer (Affiliate link)

Clear protective sheets for your stickers (Affiliate link)

Cricut Joy Xtra sticker cutting machine (Affiliate link)

Others also viewed:

📌 Location: North Hollywood, California, United States

💰 Price: $35,000

More information →

📌 Location: Reno, Nevada, United States

💰 Price: $19,500

More information →

📌 Location: Murrayville, GA., United States

💰 Price: Auction

More information →

📌 Location: Greensboro, North Carolina, United States

💰 Price: Auction

More information →

📌 Location: Grand Haven, Michigan, United States

💰 Price: $3,995

More information →

race carChevroletFordPorscheFord MustangChevrolet Camaro